Recent content by Gpops

After not being able to work on my tractor for a long time I am back and close to finishing a rebuild. When I bought the 135 the neutral safety switch wires had been cut. It started fine in neutral and I never tried to start it in gear. Does the switch only come into play if you try to start it...

In course of going through my MF135 - Z134 engine I decided to replace the water pump. The replacement pump has the fan pulley 3/8 inch further away from the engine than the original pump and does not line up with the the crank pulley by that much. Called another parts vendor and asked them to...

Does any one have any tips on re-installing the Delco distributor in a 135 with a Continental Z134 engine in terms of lining up with # 1 cylinder at TDC The manual doesn't provide a lot of info Thanks. Gpops

Looking for information regarding the swept front axle on 135s. My '65 has a single pressed in bushing that does not cover the width of the axle or the associated pivot pin. Did later models use a longer bushing? Mine shows wear that indicates the pivot pin was tilting or canting in the axle as...

Is the crankshaft pulley bolt on the 135 gas right handed threads or left. Thanks