This clutch release hub for the 1715 with double release clutch appears to be available.
Messick's has a new one and Wenger's is showing a used one.
The part number appears to be
SBA320310380
But images of this part look different than the one in your pictures. In particular, they look to be...
I don't have the schematic for the 1220 but if it is similar to the 1210, I have attached the 1210 schematic.
According to the parts list for the 1220, it should have a 3 fuse fuse-holder but only 2 fuses in it.
All of the lights pass through one fuse which is connected to the light switch. The...
The parts catalog indicates an Auxiliary Power port in that location. So essentially, it is a cigarette lighter socket.
4 different part numbers:
87313178
87302332
87313181
87302331
If the fusible link did blow (as @Harry in Ky suggests) you can find replacement info in this post: NH 1920 Fusible Link rating?
But before replacing it, you need to recheck the wiring for something that caused the fusible link to blow, such as miswiring the Key Switch.
If the fusible link...
This schematic is similar to the 1920.
I see a connection from #21 to the Instrument Panel connector.
Right opposite this connection is a connection to the Headlight/Flasher switch but I can't tell which wire it actually is.
I would inspect this connector and inside the Instrument panel for...
Can you post the 1520 schematic?
I looked at the 1920 and 2120 schematics which may be similar.
What I see is that the hot side of the fuel solenoid connects to the Instrument Panel connector and is next to the headlights on one side and the flashers on the other.
You might want to inspect this...
Which transmission does your 2120 have? The gear version or the HSS version?
Assuming that it is the HSS version:
If you mis-wired or left open the AC wire on the starter switch, then two of the fuses on the fuse box would not get power. One of these fuses feeds power to the HSS control...
I assume that this question relates to part 27 in the front axle diagram which shows two different casings (part 11) and two different seals (part 27).
Looking at the parts options for the seals, it appears that the seal for the SBA322011901 casing has 38mm inner diameter (Seal # SBA050600038)...
Answering my own questions here just for reference:
The original fusible link is Yazaki FLWX-0.85. There appears to be a new part number which is HR085-21A.
The wire appears to be 18 AWG which has an ampacity of 16A. The fusible link appears to be rated for 21A.
Various auto parts stores sell...
Heavymanuals.com has a mid-2006 operator's manual which probably covers the 2007 model too. This is the same manual as the one that @LHF2009 shows above from dmcretail.com but at half the price, $15.
New Holland TC30 Operator`s Manual
Brand: New Holland
Model: TC30 TC30 PIN HK34733 & above...
Can someone explain the purpose of the fusible link?
From looking at the schematic, everything on the non-starter side of this link is already protected by regular fuses with the start switch in the ON position.
During normal operation (ON), it would appear that the only current flowing through...
I don't know where you can get a 'free' manual.
But Heavymanuals.com has the TC30 operators manual in a downloadable pdf for $14. There are several versions. I don't know the difference between them. They also have the service manual available.
I have also used farmmanualsfree.com for my...
I have a 1999 NH 1920 which I bought used a few years ago.
When the starter motor went out last year (bad solenoid contacts), I discovered that the previous owner had replaced the fusible link with something that looks like a 30A fuse.
I didn't think much about this since it was starting just...