Recent content by gregNH

my needs are mowing (field and a lot of finish) and a bit of plowing ==> 1 acre what is the best chose R4 or turf with R4's i think i will damage my turf (a few wet areas) and with turf tires i think i couldn't plow am i wrong??? i hope so thanks

Can i pull this tiller with my tc 45 d and would it be possible for a tc 40 d ==> file type E-160 (p 4-5 ) http://www.maschionet.com/maschio/products_det.asp?id=69&lan= you can find the info on p 4 and p 5 thanks

Today i drove a manual tranny of my friend his boomer And after a few minutes i was missing my hydro it was for FEL work in narrow places at the begin it was funny to test the 12*12 but after a few minutes but i think when you have never driven a hydro it would be no problem to use the manual...

what may i expect of the quality of a yanmar engine ( landini mistral 50) and the quality of the complete tractor

I have one simple question: is it possible to plow with a tc 45 with turf tires (when the ground isn't to wet)

Gentleman, Is the tc 40 DA a good chose for mowing (finish and bush hogging) in the first place and a bit of hay making (+-5 acres) and a bit gardening ==> plowing ( +-5 acres) The finish mowing is with a 23 trees. If i take the tc 40 d (without hydro), i will buy me a little mower for mowing...

Gentleman, Is the tc 40 DA a good chose for mowing (finish and bush hogging) in the first place and a bit of hay making (+-5 acres) and a bit gardening ==> plowing ( +-5 acres) The finish mowing is with a 23 trees. If i take the tc 40 d (without hydro), i will buy me a little mower for mowing...

Maybe I will buy me a new boomer with a manual transmission. I need it for a lot of things, for the most the manual will be no problem but for mowing i' ve my doubts. It are long straight lines ==> not much changing of direction. BUT the dealer said there will be a possibility that my clutch...

I've 4 acres lawn mowing, now i've a rear mulching mower. but the result is not always good so my question is: what is the result of a mmm on a tc 45 and is it a possible to remove and clean it without losing very much time?

at a few weeks i will prepare my ground but now i had the question is it possible to plow with a tc 45 hydro (plow with 2 shears but not very very deep) or is it better to use a rotary tiller and how wide? thanks

Maybe i will buy a tc 45 with the 12X12 manuel transmission? i will use it for hay making and mowing. can you give me some advice/ are you happy with the 12*12, is it good, handy...

I've an new holland tc 45 with a hydro and the SS-front axle. But i've a question. When I am driving with my mower in 2nd range at +- 2300-2400 rpm is it somtimes hard to drive because sometimes you drive in a little pit so your foot push a bit harder on the pedal. ==> is it normal that the...

nhown-ML-740404-ML- Posted in wrong forum