Recent content by gs12jdg

how do I tell if i have the old sheet metal model or the new? attached is a picture of the plate with the serial number. I lso previous took a picture down the tube where the splined shaft goes. It doesnt really show much and I cant really see much down there. I took the steering column...

Hi, I was using my 2810 to cut a trail through the woods today and all of a sudden I have no steering at all. The steering wheel and shaft connected to it actually pull right out. Is this just a pin or something that has broke that links the steering shaft to the front axle?

Hi everyone. A few months ago I posted about my Mahindra 2810 bucket stopped curling. When I tried to pull the joystick left, it would not budge and therefore would not curl the bucket. After much discussion, I ended up unscrewing the hex bolts that hold the valve spools in place. This...

I brought my tractor home today and removed the right front wheel hoping I would be able to figure the squealing out. When I took the wheel off I was expecting to see one large nut in the middle along with the bearing, seal, etc... However I do not. Looking at the picture that I took below...

I looked at the drive shaft today. Boy was I surprised at what I found. If you look at the picture below I will try to explain what I saw. The metal tubing that is over the shaft is not going into the casing thing on the right (is this called the transfer case)? The reason for this is...

Hello, I have a Mahindra 2810 and I cannot get the 4 wheel drive to engage. It was working one day and then the next it was not. I can move the lever from 2wd to 4wd and it kinda feel like it goes in, but the front wheels do not spin. Does anyone have any suggestions for possible quick fixes?

I already swapped the hoses and confirmed that I can get the bucket to curl this way. When you say spool, I am still not sure what you are referring to. Below is a picture that I took of the control valve where the joystick is connected to it. IS the vertical cylinder thing that I circled in...

When you say "spools" are you referring to the 2 cylinders under the rubber boot that move up and down depending on which way I move the joystick? If so, the one on the right moves fine (this one appears to lower and dump the bucket depending on whether it is up or down). The one on the left...

Thank you for the reply. Pardon my ignorance but what is a spool cap? Below is a picture I took when I removed the joystick boot today. The cylinder I circled in red is what I think is the problem. When I try to pull the joystick which should make that cylinder go down and in turn curl the...

Hello, I have a Mahindra 2810 gear drive that I bought used. I haven't had any problems with it until this weekend when a load grinding/squealing sound started. It sounds like it is coming from the front right axle area. The noise only occurs when I go forward. There is no noise when I go...

Hello, I have a Mahindra 2810 tractor and I think there is a problem with the control valve / joystick for the loader. I don't know much about hydraulics, and I bought the tractor used so I am not sure if the control valve is the factory valve or if it has been replaced somewhere along the...

Hi, I have a Mahindra 2810 gear drive and this weekend I ran into some problems. I am not sure if these are all related or individual problems. This is what happened in order: 1) I noticed there was a small amount of fluid leaking out of my joystick (control valve area). 2) I could not get my...