Recent content by GuglioLS

Thank you all for chiming in. Not wanting to make a mountain out of a molehill of a project. I wound up mixing Sakcrete with the leveler for the deep end and just leveler for the last 1" to the feathered edge. The ground down concrete surface got dampened with water then a coating of adhesive...

Yes there is more than just frost here near Edgewood, NM at 7000 feet. We have real winters . The garage never freezes though, it never gets below 55* inside. The high part of the slab is already 6" thick. Just need a level surface for the wall floor plate and get rid of that slope leading down...

Thanks for the reply. There will be a 2x6 wall with an entry door right on top of the feathered edge. Then some thin laminate flooring on top of the leveler going into the basement stairs. I've decided to pour ready mix concrete to fill the deep end, let it set overnight, then pour the leveler...

I need to level a 4.5 feet long x 3 foot wide slope leading to my basement steps from the garage. The deep end of the slope is 4.5" the other end is feathered paper thin. According to the directions, Concrete leveler cannot exceed 2" thick unless "extended" with aggregate. I would rather pour...

9 pages of replies? This must have been bait just to increase everyone's post count. Now me too.

Good advise Gjamtrac - I will check that for sure and keep the unit in neutral on the first start.

Thanks BMaverick ! You are absolutely correct. Not giving up I amazingly and finally got a name and # of a super nice and willing to help Yanmar parts rep . He sent me the complete illustrated parts list for the dash APL and dash APB engines. The main difference is the APB has an engine oil...

Help! I have a 2012 Bobcat UTV 3400XL diesel with a Yanmar 3 cyl Diesel Engine model 3TNM72-APL Made by Polaris for Bobcat. After 2000 hours, the head gasket is blown, over heating, hot exhaust gasses bubbling out radiator. Rather than trying to fix that (engine and must be pulled to remove...

Help! I have a Bobcat UTV 3400XL diesel with a Yanmar 3 cyl Diesel Engine model 3TNM72-APL Made by Polaris for Bobcat. After 2000 hours, the head gasket is blown. Rather than trying to fix that (engine must be pulled) I can get a complete new old stock engine for reasonable price. However the...

Perhaps consider a cantilever gate setup where the gate is completely suspended. The gate will need to be at least twice as long as the opening (for balance) using 4 gate wheels, 2 to suspended gate above ground and 2 wheels as guides on the top of gate. Click Here for the source of cantilever...

Simple, quick, inexpensive, but don't pull an OMG where's the key ! o_O

IMHO The best solution is to use a padlock and key or a combo lock. If using a key attach the key to your tractor key ring or handy area on the ROPS where the sticks and weeds cannot dislodge the key.

George, Need to install a new double action valve between the pump and OEM blade valve. Remove the hose and hard line from the pump output all the way to the input of the blade valve. Install a new double action valve. Get a new hose made to connect from the pump output then into the input of...

Howdy there ddbackhoe, - amazing you saw and remember my redneck powder coating technique! A procedure I should have copyrighted ;) "Fire off the salamander afterwards to help the dry time." You do realize that sucker burns kerosene at the rate of about 2 gallons an hour? Have you checked the...

You wound up a good solution with the Ni Chrome wire off a dryer element. I am interested in how long it takes for the glow of your new indicator to reach peak brightness and stabilize? That glow plug indicator on my D20A-6 burned out too, maybe from leaving the glow plugs on too long? When...