Thanks guys. I had already put everything together before remembering about this forum so I think I'm going to run it a bit and see if any leaks start then tear it apart and see what's really going on. The play isn't really that much, maybe a touch over 1/16". I'll look into buying that service...
The play is the wheel stud plate.
I just wonder if I damaged it taking it apart. That side would not split apart so I tapped on the stud plate a few times until I got enough separation to get a wedge in-between the two halves to pry it apart the rest of the way. It didn't dawn on me until after...
Had to replace both spindle seals on my GC1715 and I noticed one of the hubs has a little bit of side to side play and the other side has none. How much is allowed before you need to tighten it up and how do you tighten it?
I don't know if it had play before I took it apart as that's the one...