The Yanmar 1500D is back together with a new clutch. After several trials of air bleeding it started up. Now another problem, the diesel engine runs at full speed. I have tried moving the throttle. Throttle forward is supposed to be slower - back is faster but there is little speed change if...
After 1 1/2 years of sitting I finally got around to replacing the clutch and internals on my YM 1500D. Only one problem - when finished I had 1 part left over. After looking for about 2 hours, I asked 2 buddies where it may go, no help. I have even stooped to asking my wife to see if she can...
Does anyone know the proper size socket to remove the nut that holds in the hydraulic filter (part 26 on the posted diagram)? I measured 36 mm but see there are 35mm and 36 mm sockets commonly available. Which one should I buy? Which one works best ?
I am trying to replace the clutch in my 1500D Yanmar. I took the parts out to confirm that those that I ordered were correct. That was 6 months ago. I am now trying to reassemble the clutch (all new) and the throw out bearing and carrier. The questions are:
1. The clutch plate has a flange...
My 1500d (1975 originally Green??) started squealing badly while working a blade on my road at my lake house. I adjusted the clutch linkage, ran for a while (less of a squeal) and then the tractor would not shift into gear from neutral (too much grinding) or out of gear while in gear (No more...
I recently purchased my Yanmar 1500D. It ran fine. I left the lights on and ran down the battery. I put the battery back in and reversed the polarity (The cables were installed with negative-red and positive-black). I fried the wire to the voltage regulator. I replaced the regulator, all...
I tried to start my Yanmar 1500D today which the 4th time since I bought it last weekend. It started fine before. When I turned the key nothing. I charged the battery and cleaned the terminals. I attached the pos to the battery and placed the neg black lead on the battery. I heard frying...