Halftrack's latest activity

Do a compression test. Smoke from the oil fill indicates blowby. Hit with some either to try to get it started. Sounds like low...

https://www.messicks.com/nh/142797 Attached parts diagram shows pivot arm, spring and pulley. Idler pulley appears to be available, at...

The first issue I would have with your arrangement is keeping the gear box aligned with the pulley shafts. The sleeve between the...

Surplus center also has a good selection of seats.

If the 1" equipment ìs so much cheaper and your worried about flow and pressure drop, why not put 2 1" filters in parallel, giving max...

I'm not into eclipses, they don't look like much to me. I'll stick to other photography.

Sure, it will work, but maybe 6 inches of penatration at the most.

I' did a 12' height with a 12' door on my 48 by 64 pole barn. Only regret was when it came time to concrete the floor, the trucks...

This site may have been shared earlier here but if not this is nest cam in a county park north of South Bend, IN. Looks like she is...

Digging through some older Osprey photos from my neighborhood. Endangered and reintroduced by the DNR about 15 years ago, they seem to...

It's about time I added a few photos to the batch. This nest is about 3 miles from me. The pair have a nest in this group of trees for...

I really need some help on this. I have read several posts but still need guidance. My loader valve arm broke right at the base. It...

It does not matter because there is a designed bypass so that the pump circulates the water through the block for an even warmup.

Replaced the thermostat on my tz18da. Yours looks like the same engine. Ordered and received the Stat and gasket. Drained antifreeze...