Hay Dude's latest activity

Cut quality is better with 8’ twin. Over several years of cutting, having a 13% wider cut represents a lot of time saved. An 8’ twin...

And most electricians and HVAC get their trade school tuition paid for. I think AI is going to cause a lot of people to stop thinking...

I guess we will see if we have more or less teachers in 10 years. I have my money on less. I'm not saying it will be "better".... I...

The OP could always go semi mount which puts only half its weight on the pins. Even a 3 pt mount usually has at least 10 inches or so...

I have a L4760 and have a Titan 8 foot dual gearbox cutter. It loads the tractor down the same as a 6 foot. I bought the 8 foot used...

Also, Low and dense grass like crabgrass will look like that after a cut, particularly when the sun is low in the AM or PM.

I’d check the deck for level also. The blades do overlap in the way they cut, that’s why one blade in the middle is in front of the others.

There’s NO WAY wages are keeping up with prices. Only way manufacturers are selling is through more gimmicks, like “0 percent financing”...

Most times I look at what’s happening in Houston, TX, cause that weather will be where I live 2 days later. Or I look at the weather...

My first tractor (Fordson E27n) cost me $200 cash. Brand new rear tires, but needed the main bearings re-babbited. (Mowing hills with...

I get weekly delivery from them. If I need sooner, I can get parts in one day Fed Ex ground, or as a last resort, drive up to Mount Joy...

according to the 2025 RAM builder, we were both a little off for the C&C line. 3500 - 4.10 or 3.42, 4500/5500 - 4.44 😂 one torqeflite...

Yes, you can buy the Joncutter at Amazon but it’s $155 there

I thought I read the 2025 heavier cab & chassis trucks have a max 4.30 rear now and the 4.88’s are gone? I agree with this since the...

2025 is only offered with 3.42 rear. Apparently RAM is looking for 0-60 and fuel #'s. We had a 2022 1500 with the ZF brand trans. At...