Recent content by hendr1x

Thanks for chiming in. If I am running the wrong thing I would like to know. I called the dealer and they said it was fine. Do you have a source for this? Or perhaps you can recommend I check somewhere? I take this stuff very serious as I am using 4x4 a fair amount. Thanks!

Yep they work. Thanks for everyones time.

I couldn't find anything. I never expected this would be so hard. If I don't hear anything here I'll call the dealer tomorrow and report back.

@RickB : Unfortunately mine aren't. My fronts are 6th on the list and my rears are 7th.

Sorry, I'm not clear what you mean. This is the only list I can find. I looked in the parts manual, workshop manual and owners manual. I also spent a really long time googling

Jeff9366 : Thanks for the info. I have the turf tires not the ags FYI : The manual has a list of tires but they don't show which ones (front vs back) can be paired together for proper ratios

Hello everyone, I just wanted to be 100% safe with my 4wd..can someone confirm that these are the proper tires for my tractor. Kubota L3130 Front : 27 x 10.5 - 15 Rear : 44 x 18 x R20 Thanks a bunch

So I found a picture in the owners manual attached showing the nipple....nothing attached. I then decided to go out and fill the reservior and you know what....its 100% not functional. So I guess this is stock and maybe used/drilled out on different models. So how does this work when I need...

Thanks everyone for the replies... 1) Henro : I have the manual but can't seem to find it outlined anywhere 2) Jchonline : I have the line from the radiator cap to the overflow tank. However mine goes to the cap. The cap also has another nipple (and line) that runs under the tractor. The...

Hello everyone, I just installed a block heater in my L3130. For some reason, my coolant reservoir does not have a line coming out of the bottom...just an empty nipple. The radiator has two big lines (one on top/one on bottom)...a small line from the radiator cap which goes to the reservoir...

Hello everyone, I'm just starting to use my first tractor...a Kubota L3130. I dug out a stump the other day and then tried to lift it out of the hole using my LA723 loader. Chains setup directly perpendicular (underneath) loader back/mount plate. Tractor wouldn't do it. I dug a ramp pulled...

Hello everyone, I bought my first tractor over the winter (2004 L3130 Manual 4x4 - 2k hours). Seems like I might have made a bad choice. I just found out that my serial falls into the tractors affected by PSB 2004-055. I attached the bulletin. Apparently when operating the backhoe (BH90 for...

The seal is two parts...it pulls apart really easily and the metal (inner) part is what is stuck on my shaft still. Here is a pic of the new one. Is that you? Haha...I just watched this video. I was getting all ready thinking I finally found it and you didn't show the removal...lol...

Hello tractorbynet, I have the front axle hub apart on my L3130 (4x4). I want to replace the seal that goes between the hub (part with lug nuts) and gear/knuckle housing. The part # is 34070-13370...I attached a diagram, it is 060 or 180 on it. It is basically two parts...an outer rubber seal...

So you think just a simple vent is good enough? I was thinking some sort of pressure release valve that allowed some pressure to build but not too much. I just wasn't sure what valve to use. I noticed Kubota does one but no idea if it fits on the L3130 : 35080-99700 I'm guessing I would just...