Henro's latest activity

  • Henro
    Henro replied to the thread backhoe question..
    This is a good point. Putting a 3PH backhoe back on the tractor can be difficult sometime. Maybe most of the time? That is another...
  • Henro
    I think that may be a second "most important" piece of advice... Most important being: Wear you seat belt as much as possible...
  • Henro
    Henro replied to the thread backhoe question..
    The best way is certainly using a subframe backhoe. No question at all on my mind (like the others). The easiest way is probably a...
  • Henro
    Henro replied to the thread Mahindra PTO seal keeps coming out.
    Might be time to check the shaft to ensure it is running true, as suggested by DarkBlack in post #6.
  • Henro
    Henro replied to the thread Rear Axle Seal Leak (BX2200).
    I was curious about how the axle came out if a seal needs replaced. Seems you would pry out the seal, remove the external snap ring...
    • IMG_2727.jpeg
  • Henro
    Henro replied to the thread Bent bucket roll cylinders.
    Especially on the same day and only five minutes apart! 😳
  • Henro
    Henro replied to the thread Bent bucket roll cylinders.
    Sorry but it is a bit strange to post the same question twice in different threads on the same site…
  • Henro
    Henro replied to the thread Bent bucket roll cylinders.
    See this current thread…. https://www.tractorbynet.com/forums/threads/bent-bucket-roll-cylinders.585606/
  • Henro
    Henro replied to the thread Bent bucket roll cylinders.
    Certainly true. Problem being is cylinder rods are not really designed for compressive force when fully extended. In tension there’s no...
  • Henro
    Frankly, rather than resurrect a 15-year-old plus thread, it would probably make sense in the future to just post the new question as a...
  • Henro
    Henro replied to the thread Hydrostatic drive.
    You might ask the same question at the orange tractor talk (OTT) forum. Lots of knowledgeable people there too…
  • Henro
    Henro replied to the thread BX2200 Starter Issue.
    Where did you mount the relay? I mounted mine on the frame rather than on the engine where is would be subjected to lots of vibration...
  • Henro
    Henro reacted to BravoXray's post in the thread Got rid of the wheel bolts. with Good Post Good Post.
    Because that's what I had in my toolbox. Didn't feel like spending another $20 on a bottle of red that I would probably never use again...
  • Henro
    Henro replied to the thread Got rid of the wheel bolts..
    Hummmmm...Why blue? I would have used red LOCTITE myself. Just curious...
  • Henro
    Aside from a relatively smooth start if using my rotary cutter, the most useful feature of the foot clutch that I noticed, is the...
Top