Recent content by iis

pics:

My l3200 manual says not to change the hydro fluid at 50 hours. I don't want to rehash the issue but maybe we can take a poll? At the 50 hour maintenance point what did you do knowing Kubota does not recommend it?

I just clamped it on and it will be .5 inch to short on each side. Should I bail?

Just purchased a 66" cutting edge protector: 66" Reversible Bolt-On Cutting Edge 86577167 It is 3/4 inches thick. Is it possible that this may be to thick for my bucket and cause issues? (kubota l3200)

An earlier thread ("alt/sand box for the driveway")describes a system where the FEL is partially blocked off to control sand distribution. It is not discussed if it is a good idea to use the FEL as a giant salt shaker. I like this idea but I have about 150ft that needs to be sanded and I don't...

I would like to add an extra cross section of vbar since these tire chains have a rather large area without studs. Anybody see anything wrong with just laying them over and attaching to the side chains?

Will a two link ladder chain fall between the treads?

Any clearance issues with the outer tie rod?

I have a 1200 ft driveway that is steep in one area. I previously used a 4x4 pickup with v bar chains on all wheels. This setup allowed me to grip ice without a problem. I am looking to buy a new B series Kubota(2650 or 3200) and have read all the posts here regarding traction. I know that V...