Recent content by Illini22

I figured it out. It was the cruise control switch that must’ve been flipped on.

My dk40 hst peddle seemed hard to push, I then noticed a dash light that isn’t in the manual. It shows a tractor with a paddle lock underneath it with an arrow going forward. When I push the brake on, the light goes off and peddle is easy to push, when I release pressure on brake, light comes...

Thank you for the reply’s!! Yes I did the same thing, drilled two holes to make removing the joystick easier if I need to do it again. The cable end connector (aluminum) at the spool valve ended up being the problem. But I had taken the wheel, fender off before disassembling. I drilled the holes...

Looks like I have a broken cable or connection to the joystick cable running to the loader valve. The raise/lower suddenly went limp. The balls (steel) appear to be fine, but there’s no pressure on the one that goes to the up/down. To get to the bolts to remove the joystick housing it...

My 2014 dk40 started leaking hydraulic fluid underneath the trans area. The independent tractor repair (heavy equipment too) facility split the tractor, found the seal or gasket that was the problem. They called me because they are having a problem getting a “parts breakdown” from the Kioti...

Could be very dangerous

It looks like two "thumbs up" facing in. I looked in my owners manual and don't see it in there. I'll try to load a picture.

Most, if not every deck over I see are only rated for 10k pounds?

http://youtu.be/9FEaEHXWWw4

Not that I need another one but this has hydraulic scarifiers. I offered $750. Is the a 3k plus box blade?

I believe the model is 72" cyclone, it has captured pins and just a ton of metal around it. The gear box looks a little different from most other rotary cutters I've seen. I hear rhino/ Servis is a good brand. But I'm worried it may be a little to much. I do have a loader for counter weight...

Both look to be in similar condition. The md has captured pins for the 3 point . The bb72 does not, although the newer bb72x does. The md looks a little beefier, but from reading here the gear box is far more important. The md is $1000 the bb72 is $1400.

6'4"x10 galvanized. Radial tires with hydrogen. Gate folds flat into bed and is removed easily, spring assist. 4 d rings, sealed wiring. I purchased it from RP carriages in Seneca il. Extremely nice people (and knowledgable) to deal with

Get one that hangs off the side of the bucket!! Lol. It worked pretty good considering all the pit run (round Potato sized rocks). I borrowed it from a buddy who uses it on a good sized new holland skid steer. So the hydraulic flow/ pressure was probably not ideal for my 11.9 gpm on my dk40. I...

Last time I was at my property I noticed that my dk40 was creeping backwards. It had never done this before. I have put 3 hours on it since the 50 hour fluids change. I topped off the hydro fluid because it was barely on the dip stick. It's still very hard to see (clear). Would an over filled...