In.the.Piñons's latest activity
-
IIn.the.Piñons reacted to 4570Man's post in the thread Hydraulic auger recommendations for my FEL with
Good Post.
You only need the cross relief port if the attachment has a lot of kinetic energy which the auger does not. My auger doesn’t have one... -
IIn.the.Piñons reacted to bob11x's post in the thread Hydraulic auger recommendations for my FEL with Good Post.
The auger can be lifted into a catch on the left and right side (when center mounted) for moving about and also can keep it compact for...
-
IIn.the.Piñons reacted to RjCorazza's post in the thread Hydraulic auger recommendations for my FEL with Good Post.
My Land Pride ssqa auger gets stored on a pallet shelf, with the auger disconnected. I fork the pallet off the shelf, remove the forks...
-
IIn.the.Piñons replied to the thread Hydraulic auger recommendations for my FEL.Nice! How do you store it when not it use. Can you just lay it on the ground like a bucket and use the FEL to pick it up when you need...
-
IIn.the.Piñons reacted to bob11x's post in the thread Hydraulic auger recommendations for my FEL with Good Post.
I can’t say with any authority but should be fine. I bought a Landpride SA20 for my kubota L3901. There are different motors depending...
-
IIn.the.Piñons replied to the thread 88" box blade on a 84.5" wide tractor?.I've just added a hydraulic angle adjust to my blade along with a hydro top link (it already has hydro tilt and offset), but I can't use...
-
IIn.the.Piñons reacted to jyoutz's post in the thread 88" box blade on a 84.5" wide tractor? with Good Post.
Everyone’s road conditions are different. I sold my box blade after buying my heavy 8’ 6 way blade because I found that I wasn’t using...
-
II built a frame and hang it from a chain and turnbuckle. This allows me to move it around when hooking it up to my tractor. I rarely...
-
IIn.the.Piñons reacted to scootr's post in the thread Land plane for grading lumpy land (not a driveway) with Good Post.
I have used the LP with good results on our clay soil. The key to any dirt work is to ensure the moisture content is right. Too wet is a...
-
IIn.the.Piñons reacted to jyoutz's post in the thread 88" box blade on a 84.5" wide tractor? with Good Post.
Since you don’t tilt box blades like you do straight blades, covering the wheel width is all that’s necessary, especially since you have...
-
IIn.the.Piñons replied to the thread 88" box blade on a 84.5" wide tractor?.My blade came with wings and I've used them to grade out a section of steep dirt road that was in very bad shape. It worked, but seem...
-
IMy tractor has a ~18gpm flow rate (not sure on the PSI though). I'll be routing hydraulic lines from the (stock) rear remote up to the...
-
II found a used BB that I'm interested in, but I wonder if it's a little to narrow for my tractor. Used ones, rated for my tractor's HP...
-
IIn.the.Piñons reacted to bdhsfz6's post in the thread Regret not getting a backhoe for my tractor with Good Post.
I bought my first backhoe attachment when I was in my 40's and it took less than 10 minutes to put it on and do the take off. When I was...
-
IIn.the.Piñons replied to the thread Regret not getting a backhoe for my tractor.But, it's only when you have a one ton and an excavator, that can you live your life with no ragrets!
-
