Recent content by itsmesrd

Big line is low pressure "inlet" to the hyd pump, small line is high pressure "discharge from the pump. Big line "green" connects to the trans housing towards rear of tractor, green circle opposite side is where hyd filter is located. Small line snakes its way to top of trans housing red...

I was finally able to get the pages showing the 3ph to scan for me

not sure that you will be able to see this the flat just above the inlet has "15CHM" stamped in it looks like "KATABA" OR "KAYABA" between top and bottom flat Top flat has "5L-1" stamped. I can't seem to find anything on the net about this pump

Shots of the front of the front of the lift housing cover. Could the number on the housing indicate the year the housing was made and the number of units to that point? I agree about the danger, in fact that is how one of my uncles was killed. That point was driven home to me just the other day...

I cranked the tractor yesterday to put it under the lean-to on side of the garage out of the rain. And tested the PTO for direction. It turns clockwise when looking from the rear. "Bush hog" is use around here to mean any sort of rear mounted lawn mower type bush cutter. Yes the tires look...

found another number under the paint on trans housing

found another number on the trans case

Not sure why I can't insert an image. Computers are the most frustrating things sometime. I know that the button above should let do it but does it NOOOOO! I have had the tractor for a couple of weeks so I'm not too sure how long its had problems. But I would say that the bungee cord screwed to...

I've finally got the water out of the system and discovered that that didn't solve my problem. I have to rev the engine very high to get the 3-point to pick up the bush hog or anything that I hook to it. Even at higher revs the thing still leaks down and will not pick it up until I work the lift...

Hello everyone, new guy here. Two weeks ago I bought a Mitsubishi D2000 from my nephew. The little tractor came with a bush hog and a small set of chopper discs. Finally got it home day before yesterday, and discovered that the 3 point was very slow lifting the bush hog unless the engine RPM...