JC2398's latest activity

Lol…I saw a thread about ghost stories in another website that went on for years. Always good to have ideas & conversations; I just...

If you can get a jack under the bucket, you can raise it by hand, then figure out a way to strap it into the position that works for you.

The question is will this thread continue on with people not reading the replies and continue to tell you what to do? Glad you figured...

An electric switch cannot be partially-engaged, it's either on or off unless it is damaged or failed.

Yes sir & thank you! I was kind of surprised to be honest; always a relief when you get stuff working again though!

Doesn't it feel so good when you figure it out!!! Good on ya' for finding it! [emoji106]

Update: Got it running…Ended up being the seat safety switch. I bought a bypass on Amazon ($11 for a three pack). I’ve got a thread on...

Get a chain under the bucket and tie to the tractor axle or frame. Push the loader lift control full forward into the float position and...

I have it happen often. The PTO lever is off, but the switch isn't quite in the right position. If you had read further you would see...

One "trick" I learned from my uncle when loading a tractor in uncertain conditions. Let out air from the tires to increase rolling...

If the engine turned over this discussion wouldn't exist. Yet you raise a good point. We tried to lift the loader on my father's 4400...

Most tractor hydraulics will lift by pulling the "up" lever back and turning the engine over on the starter. It should lift enough to...

Looks like a Dukes of Hazzard "rollback"

The easiest and quickest way is to run a chain or winch cable under the bucket and pull it on the trailer or truck.The loader will rise...

Remove the bucket. Try cranking the engine while holding on the Lift Lever. You might also Try Jacking up the bucket while tying down...