Recent content by JD3520

Thank you. My speed sensor has been out for awhile and I couldn’t locate it from 2 descriptions found elsewhere. Your write up was right on the money. Err06 is now gone. Working on a plate to mount in front of the sensor and wire to protect it.

I had to stretch some wire today and found a new use for my I-match hitch that may have already been used. I have a bar filled with cement I use to tap the dirt around posts to make them set better. I put the bar thru the rolls of barbed wire. I layed the bar in the lower hook up points of...

I noticed a hay spear is listed for the 300cx loader on a JD3520 but not a 300x loader. Has anyone used their 300x loader to lift a hay bale? I'm thinking about buying a spear for my 300x loader and don't want to waste the money if it will not work. I guess I could chain a bale to my loader...

Anyone found a picture of a 20 series with the front fender kit? I'm picturing an odd looking item but I will hold final opinion unti I see the pic. chuck

I did not get the third SCV when I bought my 3520 and now want/need one. Is this something I can add on or is it better to let the dealer install it? The picture in JD parts shows a kit but that is only a lever, pins, pipe couplings, and hoses with female connectors. It doesn't show where to...

This is very sad! I work for a sheriff's department and today we had a call we all need to be concerned about. It was a beautiful holiday in Texas so everyone was outside and/or visiting with friends. Got a call about noon of a vehicle speeding down the road. It ended up at the emergency...

My brother-in-law has a jd 4010. He says the cruise control stays activated when he hits his brakes. Seems that would be dangerous. Question to any 4010 owner. Does your 4010 cruise control disengage when you hit your brakes? chuck

I seem to have more questions than answers today. I was looking at and old post of a CUT being used to bale round bales. It showed the Hesson 730 round baler and the specs showed a 30 pto hp minimum. Here is my question. Are the hp requirements for a square baler less than a round baler? My...

Can anyone tell me if my 3520 will pull two moldboard plows or two middle busters. I went thru the bone pile at my dad's old place and found parts to piece together a 3ph bar (to attach things to) and plow attachments. The 3ph bar was orginallly set up with one middle buster because he always...

Just went out to play. MY tractor and I are taking alittle trip next weekend so I loaded it on the trailer today to check some things. Trailer is a standard gooseneck with bed over the wheels. I noticed when unloading the tractor (3520 w/ e-hydro) it will ease off the trailer very slowly...

I have added some tool boxes made of old army ammo cans to my jd3520 and some equipment. Used rust-oleum farm equipment paint to paint them. I wasn't expecting much but boy was I surprised. And less than $5.00 a can. The "matches john deere green" color matched almost perfectly. You can't...

On the right rear of my 3520 (above the axle and below the fender) there are two two-wire connectors that are capped off. One is labeled "REARWARD" and the other is labeled "FORWARD". There is a third that is not labeled and capped off. The tractor has no optional buttons on the fender...

Just bought a JD3520 (3 total hours on the machine). I was wondering what the LoadMatch function really does and when it would be used. The operator manual does not give much info.