Mine is on a receiver hitch now. The older I get, the heavier it gets. Where I am, the risk of theft is relatively low, I might just leave it as-is and put a cover on it since it has synthetic rope.
I want to put winch in a box but am trying to keep the existing box for straps, etc. I would also like to leave everything needed on the trailer in place of keeping it in shop and having to gather it all up when needed. While typing this I thought a recessed strap box might be an idea, then put...
I have a winch on my trailer with a receiver mount. It's great until you have to install the winch on the trailer. It's gained weight in the last twenty-five years. I have a tongue box which I want to keep using for tie downs. I'm thinking about putting a narrow box on the front of the trailer...
I think it's a good idea, especially if it works. I have a question on your sub-soiler. I thought the lift pins and the top link were supposed to be in a vertical line with each other. Is that working ok? I have a sub-soiler, rototiller and finish mower to adapt.
Any concerns about the long arms putting too much torque on the loader arms when in use? Is that even an issue with tractors having such a low GPM on the hydraulics? I have an old Ford auger very similar to yours I might convert like that.
I have a pre-emissions Case DX35 and have thought about moving up to a 50-60 HP compact. I was looking at a used Kubota L6060 with a DPF and still not sure if I want to buy. Dumb question inbound. Do the new tractors that use exhaust fluid still regen or did the fluid make that unnecessary?
If you haven't seen it already look up RapidAir Maxline. It's some of the pex al pex. A little pricey bit it works well. You'll definitely want a moisture separator where it comes out of the ground.
I've looked at several of the land plane builds but I have one question. I can't tell by the photos what I need. I'm using the Gordon Gould build as a reference. I have 4 inch angle to mount the cutting blades I'm "borrowing" from my box blade. What is a good vertical angle to mount the cutters...
It's a 24 ft. 10K trailer bumper pull. I ended up fastening to the front channel and the first crossmember, and also to the front bumper crossbeam. It will just be used if I have a dead car to load. Not likely I'll drag something that won't roll. I have a 3700 lb. Warn that easily pulled...
I recently acquired a new trailer and I’m working on installing a receiver for a winch. The toolbox is welded against the front rail, so that adds a level of difficulty. Putting a winch in the box would be ok, but there’s not enough room to mount the fairlead. I’m thinking about laying a piece...
I'm thinking of getting some #1 battery cable and running from the truck battery to the back bumper and putting a high amp quick connect on it. I'm putting a winch on my new car hauler and on my small trailer I use to haul a zero turn. I found out how hard a dead zero turn is to load. I figure I...
If I can find a decent used gooseneck that’s probably the route I’ll take. I’m trying to stay under $7,000.00 which would buy a new 10k 24ft TT or hopefully a good used 14k gooseneck. I towed my DX35 on an 18ft trailer without any sway issues but there wasn’t room for adjustment.