Recent content by JerryG

Av8tr72, The last of Mossroad's last post where the highlighted Draft control and Position control, sums it up in a nut shell. The part about digging holes was a little a little strange but follow what he posted and you won't go wrong

I know it's been a while since you posted and I hope you've got it straightened out. If not continue. From my experience your radiator is still dirty. You can do all the remedies and it will look clean in the outside and it still won't be. In the center of the fins that's very had to see...

Hello there. I hope you have her tractor/loader working by now, if not continue. Sounds the me like you have quick connector that's not seated right. Connectors can look and feel like they are connected and still not let fluid through. On the lines going to the loader, disconnect them and...

If you really want to level 60 acres or even a large portion of it it will be very expensive. It looks like given you said that one contractor wanted $2000 an hour your serious. I have done a lot of leveling over t he e years but this is to much for your tractor or even any light equipment. You...

Red Bellied Snake From this site below. Wish more information was given. Snakes

The 1260 will handle a 4x4 and lighter 4x5. Anything larger you can't lift. This is with the loader.

That is what I was getting ready to say. They usually do but they give it enough time to be sure everything is taken care of.

There is a level that needs to be engaged first. I can't remember is it is to the left of and behind the seat or if it is back by the PTO shaft and to the left. That was about when they went from the seat location to the rear location. Anyway, that lever has to be engaged first. Then when you...

I don't think people will ever learn. Here are a couple of pictures we took with my cell phone. We were on the interstate going about 65 mph when these were taken.

All the compacts are made for AGCO by Iseki in Japan. The utility size are made by AGCO but are Masseys. There are a few that have Cat engines in them for the Challenger line.

Ok, I sent two or maybe three e-mails to the administration about this problem over the last several weeks and never got any kind of response. Here is what is going on. If I click on to the Gallery tab at the top of the page, then click on My Gallery at the top of the next page. It takes me to...

That would be on the big side.

Is this mower a finish mower or a rotary cutter (Bush Hog type)?

I have a fiberglass camper shell cap on my F150. It was on the truck when I bought it, so I don't know what effect it has on mileage. It is level with the top of the cab and it has the sealed pass though to the cab. What I want to know is how does it effect gas mileage? Will the mileage be...

They have Iseki like the Massey and AGCO compacts.