Recent content by jerryjg

  1. J

    s370 reproduced decals

    I have 4 sets of reproduced decals for a s370 beaver. asking $70.00 a set.
  2. J

    PTO Satoh s370

    What type of oil goes in the PTO on a satoh s370 it is the reverser type?
  3. J

    satoh s370

    it has been a long process but it is running now a little hard to start new wiring except for the 3 lights oil temp and heat cleaned them up new bulbs work fine now. :cool2: the pressures I posted were wrong I used a low quality tester they read 1 just at 300 psi and 2 at 325 psi.
  4. J

    old style glow plug indicator wire type

    does the glow plug indicator stay red hot while the key is in the heat setting? mine will stay red hot for around 12 seconds then fade out with the key still in the heat setting.
  5. J

    glow plug indicator on a satoh beaver

    the glow plug indicator smokes a little when I put the switch to heat then the coil gets red hot for 10 t0 12 seconds then fades to a dim red almost can not see it glow. I have rewired with new wires and switch. how long does the glow indicator typically stay red. the tractor had a push button...
  6. J

    starting problems satoh s370

    having starting problems the glow plug indicator works for about 10 to 12 seconds then goes dim. when I try to start black smoke pours out exhaust. I have heated the motor it is inside my shop. I drained the old fuel out bleed air out and checked the injectors they have a good spray pattern. if...
  7. J

    satoh s370 pictures

    started putting back together trying to put new wiring what a headache trying to install a new regulator.
  8. J

    satoh s370 switch wire

    installing a new wiring harness and regulator. where does the 2 wires from the glow indicator go? one goes to terminal when switch is turned for preheat can not figure where the second one goes. I should say 3, the long one goes to the glow plugs. thanks for any help.
  9. J

    satoh s370 clutch not releasing

    I am in the process putting my satoh back together got the wheels on went to move it pushed the clutch down did not release? I put the same clutch linkage back on it when I finished painting it. any help would be great. thanks
  10. J

    satoh s370 beaver

    I have a s370 beaver satoh it has ran well for the 4 weeks I have had it last I put it up was running with no problems. I had changed oil ,trans fluid new fuel filter now when I start it at low rpm it runs rough but will idle when I give more fuel it smokes black smoke and very noisy. I checked...
Top