Recent content by Jervis

Sorry for the late reply, I have put another 200 hours on the tractor. I don’t find it has gotten any worse but I keep it out of 4th gear as it is substantially louder as compared to the others. There was a needle bearing on the range transmission shaft that was supposedly narrower or something...

I encountered a problem with our 2008 ck20 hst the other day and figured I’d post about incase anyone else has a similar problem. We had been experiencing a strange scrapping/squealing noise coming from the clutch/bellhousing area for quite some time when using the loader and lifting heavy...

Sorry for the late reply guys. I ended up selling the tractor. Not for that reason but I had an opportunity to buy a nice low hour massey 1648. The guy I sold it to is still operating it and has not reported any issues. Sorry I couldn’t be of more help.

Hello, I recently purchased a 2012 Massey Ferguson 1648 with dyna qps transmission. The tractor has been very well taken care of with 230 hrs. I have put about 15 of those hours on since I bought it. I have noticed there is a rattling noise I will call it, when operating the tractor in 4th...

I have recently purchased a 1990 m5950dt. I have concern/question about the tractor in regards to a growling noise when the transmission is in neutral with the clutch engaged. The noise sounds similar to a bad throw out bearing but the clutch is engaged so the throw out bearing shouldn稚 be...

yes i didnt sorry i didnt post pictures, here is the finished project

Hello, I am experiencing problems with the front end loader of the new to me b2630. The tractor is a 2012 with 225 hrs on it. The problem occurred over the last two days while the temperatures were below freezing. The tractor is equipped with the fender mounted joystick that his cable operated...

hello, I just picked up a B2630 with the bh77 backhoe and I would like to make a thumb for it. Can someone provide me with a couple dimensions? I am looking for the distance from the pivot pin to the telescoping arm pin on the thumb arm. I would also like the telescoping arm dimensions...

I recently broke the from axle joint on my G174 and am having a hard time finding parts. If anyone has one kicking around or knows of somewhere to get one it would be much appreciated. Thanks

Hey fellas, We have recently purchased an old 50A backhoe and has worked well up until a day ago. I was digging with the hoe when suddenly it wouldn't swing left. Still swings to the right just fine but not left. I have swapped the external PRV for both sides with no change. I should note that...

I just bought an old backhoe to do some work around a new piece of property. Noticed a small leak between the engine and the tranny. I think it's the rear main seal. I have asked around and some people have mentioned that its the old rope type seal and can be replaced by dropping the pan and...

I have a 2008 ck20s and have noticed that when going into a pile to get a load in the bucket if my tires have good traction the transmission will slip instead of bogging down the tractor. We had a little kubota before this tractor and it would bog the motor down before it would ever slip. I...

Hi fellas Just bought an old 74 50A with cab for clearing a few stumps and brush on the new property we bought. The machine is in pretty decent shape for the year, needs a seal in the right out rigger cylinder and the top bushing in the swing is bad. Engine starts and idles extremely smooth...