Recent content by jkb7810

Not sure if anyone has brought this up yet. https://www.zuidbergna.com/front-3-point-hitch-front-pto/

So, I have it all plumbed and had a leak show up after I was using it for awhile. Seems to be coming from the factory installed pressure relief valve. My question is when I take it apart the put some sealer on it ,will it come out clean or are there springs behind it? I only know enough about...

I've got it a plumbed and been using it some. Going to make a bracket for FEL lines and I did put QD's buy the other ones.

We guys here is an update on the progress. I've started the plumbing and of course, missing a couple of things. Here are some pictures that I can check out and give me some feedback on. Also, here is a link to some of the information that I've been going by.

I did look at that one also. I went with CTA 50 inch.

Bigtiller, the weights are off a old JD combine . There right around 100lbs each and make a big difference for stability with the FEL. I will have to remove the right rear from my 2720 to get access to the hydraulic block.

Well I have finally got around to building the bracket for the 3 spool valve I bought. Here are some pictures of the mock up. My plan from the original idea has changed so I will have to get some other fittings, when the plumbing starts. I also took a picture of the 100lb weight that I spoke...

I would like into a 2 series. I was looking at the 1025r. Than ran across a 2720 used. Way more tractor and it would match the implements that you have.

Sorry forgot to say they have a loader selection guide. Ta-111 is what they recommend. Try it out and give them all the info.

Try loaders.com. It's a company called Westendorf and they make a good loader for smaller tractors. Get much over 120hp with mfwd and be careful using them.

Thanks I'll check it out.

Just a update. I've got the grapple here and it really looks great. Now I just have to find the time the make the bracket for the valve and a location. Not much room on these little things. LoL

U

All great add ons. Now I have me thinking 🤔

I have a quote coming for the 50in grapple from CTA. Pretty sure I'm going with them. Now all I have to do is get the power beyond and valve's put on. O yeah and gripe about the 100lb weights I put on it. LoL .Pretty sure I have all the parts for it. Just have to build the bracket's.