Recent content by jmk121

Will do, Thanks!

The pump is most likely repairable if I can find a seal kit. Minor wear on the metal parts I think I can clean up the scoring on the sides of the gears. There are some threads on here about availability of seal kits and my dealer did not have a part number for one. I need to check the female...

The new pump is installed. It works great. With the tractor hot (or cold) it will raise the front end off the ground and roll the bucket down lifting the tractor at idle. It will lift my 72 inch grader box to full height with the three point hitch at idle. Engine oil and filter changed. I reset...

You are correct . I think hydro fluid was in the middle of the dipstick marks. I was wondering what angle if any would uncover the pickup for the pump. The tractor got very hot when I was trying to get it out that might be what damaged the pump.

Thanks everyone for the help. I talked to Robertson equipment and the mechanic said he thought the pump was bad also. I removed the pump and disassembled it. First the long bolts that hold the sections together two were not tight (they loosened with finger pressure around the head of the...

I tried to order the relief valve and it is on backorder. what usually goes bad in the relief valve? it has two internal moving parts a spring and orings. no scoring is present on the moving parts. the orings are replaced since the problem started. does the spring weaken? I have tried the...

Thanks, I will try that.

no rear remotes I have looked for another valve after the lift valve and dont find one. Thanks

This is the thread I was using: "From what I have found for a Baldwin is this Hydraulic Daedong=T2185-38031, Wix=57098, Baldwin=BT8488 HST Daedong=T2195-38031, Wix=57350, Baldwin=BT8898"

Thanks, i am pretty sure filters are corect. there is an old thread on here about filter cross reference which lists baldwin, wix and maybe some others that cross. In any case the problem started with the Kioti part number filters installed.

how would I get the trapped air out of the suction line?

Thanks, I am trying to decide if I should just buy a new presure relief valve or pump. I saw an old post on here where someone had similar issues and the dealer replaced the relief valve to fix it.

No noticible foam on the dipstick when hot. I dont see anything obviously cracked, but have thougt that a loss of suction could be the problem. I have inspected all the lines under the tractor for kinks or bends and they look fine. The fluid is filled to the top line on the dipstick. I dont know...

Thanks for the replys. I have changed the fluid and filters since the problem started with no change. I went from a daedong to wix on the hydraulic, and the hst is a daedong. I have looked in the manual and dont see a screen but will look again. The only pressure relief valve I can find is the...