The angles matter or the wheel won't stay plumb. Its really the angle where it bolts and the angle where the bearing shaft is welded that I'm hunting for. I measured all four and they are all different because they have all been bent so much. I can just built them and then drill the holes at...
I have bent the crap out of all my wheel arms on my early King Kutter 6' finish mower. It's impossible for me to get the miter angles correct to make new ones. Doesn't anyone have straight ones they can measure or a CAD file so I can just cut new ones out? Mine are the earliest version which...
Hey folks,
I have a 1648. Over the last year the total lifting capacity and overall backhoe power (PB) has diminished. I move full skids of feed and I can't pickup a full skid anymore. It's like a relief valve is opening prematurely.
Does anyone have the line drawing of the hydraulics from...
This sounds like an expensive prospect as the PTO driven pump and cooler units are more than the cost of a decent skit steer brush cutter...
Not ideal. Any other ideas? renting a forestry mulcher is in the thousands and I'll need to be able to bushhog it or use a flail mower over it...
Looking to add a hydraulic brush cutter (standard flow) to the front of my loader on an MF 1648. Max flow is 16gpm on the tractor. Looking to use power beyond to hit a motor control valve and use that to power the brush cutter. Seems simple enough. What am I missing? Has anyone tried this...
I've been trying to find an R4 or something like it for my 1648. I'm been told from the dealer they were only R1 models... which I found R4s in a product book as in option but nothing else about ordering or part numbers. The drive ratio is 1.61 and I'm told by the tire stores I'll have to get...