I have read that the high pressure tubing could have bod o rings or are cracked. I have a full service manual that shows them but does not detail how to get to them while on the tractor. Everything from the manufacturer assumes the engine, trans or hydraulics are removed from the unit. Anyone...
I blew a hose and subsequently changed it. I used it for nearly two hours after the change but towards the end, the machine stopped going forward in forward. It would still push backward IN FORWARD!!! So fluid levels looked a bit low, I have topped them off. I have run the machine for a few...
My backhoe stopped going forward toward the end of my task of moving item 4 from the driveway to under the deck. I pushed it to its parking spot and set to researching the possible cause. The first discussions that caught my eye was that the trans stopped functioning while it was hot SO I...
While running loads of item 4 out of the driveway with a lot of forward, reverse, forward, reverse work, the forward stopped working. I had to push the unit out of the driveway with the boom. It will just not engage in forward and I have no idea why. Any ideas? I did just blow and replace a...
As a rookie, I just broke my first hydraulic hose, and it is somewhat buried behind a couple other hoses. ALL of them are original to my 1975 International 3500A and they won't come off. I am soaking them with PB Blaster but it is not the blaster of old by far. Any other advice to break these...
Hello everyone - thanks for coming together for this informational forum. As a rookie, I just broke my first hydraulic hose, and it is somewhat buried behind a couple other hoses. ALL of them are original to my 1975 International 3500A and they won't come off. I am soaking them with PB...