Recent content by JNB

The dealer could not identify the part needed. I have been chasing after the wrong part. THe dealers best guess is part #5 - The main shaft. Attached is a picture of the damaged part and the schematic. THe photo was taken of the compartment in the housing furthest away from the front. I took the...

Now I am confused by the responses. THe New Holland dealer said I needed part # SBA322531670. The responses I get from the internet used parts dealers says its part #SBA 322571410 and they have the schematic diagram, which I also have, to verify it. Who is right? Are they the same part with...

I have tried every website - no one has the part - it has been discontinued. What are the alternatives? Tried bush-hogging this weekend - constantly riding the clutch in thick brush. Any suggestion would be appreciated ( I was out of the country for a while - hence the late response)

Looking everywhere with no sucess. WIthout the part the low gear will not work as the shaft is damaged. Thanks for an assistance.

The label on my tractor says it is a TC40A. When the serial number is inserted on the New Holland Website - it comes up as a TC40DA. I need to know the difference between the 2 so that I can identify which one my tractor is. I called their support - couldn't help. There is a separate manual for...

I live in Florida and have a 2 acre plot which I would like to farm. The land fllods easily when it rains. I have a ditch in the center where I can have the water run into so I can pump it off. I am thinking of running my moldboard plow on both sides of a line creating a bed - but because the...

I have a 2006 New Holland TC40DA. Started it yesterday morning then shut it off. Came back 5 minuted later - Engine turns over but wouldnt start. Called two friends over who Changed the fuel filter - (looked like crap, there was water at the bottom of the bowl also). They put a gas rag over the...

I have a New Holland TC40. It starts but it will not go into gear. If any of the transmisssion related levers are in neutral, all the gear levers would move. However If I try to engage it out odf neutral, the levers will not move or the gears grate. I sometimes am able to get it to move in low...

My NH TC 40 had its battery replaced a year and a half ago. The original (2006) leaked and it was replaced under warranty. The tractor didnt start yeasterday - checked fluid - it was nearly all gone. Threw in some battery acid I had lying around from filling my motorcycle battery and added some...

I have 2 expired tanks, took them to be refilled. The store refused to fill them - thats okay. They also refused to recertify them. They were expecting me to buy new tanks from them. I live in West Palm in Fl. Is there a requirement for the shops to recertify at a cost? Does anyone know where I...

What kind of pump am I supposed to use? I used a water pump to wash my tractor and restricted the flow to increase pressure - ruined my pump. Now if I did that to my garden sprinkler pump - it will not ruin the pump. What is the differnce in pumps?

I am trying to make some garden beds and decided to try the mulboard plow. There is a two bottom and a one bottom plow. What is the difference - beside the 2 bottom being more expensive. I only have an acre to cultivate. Is there a better way to make garden beds?

I live in West Palm , FL. I have access to water. I need to irrigate a nursery once per week by spraying the water over the nursery. I have seen the tractors in the area do this. The water goes out at least 50 yds in the air in a stream - more like a gian sized sprinkler head. Would a roller...

Is it normal for my tractor to lose lifting power after working for about three hours? I guess the service center did not believe me since they could not find the fault. They were certaily not going to work it three hours to test it. Currently the tractor is at the dealer for service and I did...

I have a 2 yr old TC 40A. It has 250 hrs with a manual transmission. Moving between Low and Medium is a real PITA. YOu have to try then tap it into position - really wasting time if you are moving dirt and constantly changing gears. I expected the problem was going to go away with wearage. Does...