Recent content by JoeyDude

I upgraded my Max28 FEL to SSQA about a year ago. I went with the WR Long adapter (WRL-APUM2) and it works well. The downside, as others pointed out, was that I lose some leverage in lift & curl. The pin holes are not ideally placed and could easily move a couple inches further forward if...

I had the Mahindra thumb installed when I purchased the tractor. Unfortunately, it bent on the first day with the very first rock I picked up. In all fairness, it was a big rock and right at the limit of the dipper. Since then, I've straightened the thumb several times and it continues to get...

I recently add a 12 volt outlet to the dash of my tractor ( http://www.tractorbynet.com/forums/mahindra-owning-operating/349764-12-volt-outlet-mahindra-max28.html ) and figured while I was at it and had everything apart, I might as well add a horn. I ran a dedicated line from the battery to the...

One of the minor annoyances about my Mahindra Max28 is that it has no cigarette power plug. This ranks right up there with the lack of a cup holder. So, I've installed one onto the left side dash control overlay cover plate. The dash is a bit of a pain to take apart and linuxman51 did a...

I used Ken's Bolt On Grab Hooks. They are well made, easy to install and STRONG. My installation video

I just went through this with my old walk behind John Deere TRX snowblower. Apparently, I had hit enough rocks over the 20 plus years I've had it to finally damage the impeller to the point it was scraping the inside. Much like you, I had to hammer the snot out of it to straighten it out...

That's a good size load! I did a similar lift with my Mahindra MAX28XL using Titan clamp on bucket forks. There were 15 bags of general purpose stone (48 lbs each) and 5 bags of river pebbles (50 lbs each). One bag slid off the pallet as I started to unload it with my tractor, making the...