Thanks for the information. That hole seems so miniscule, that it was hard to believe that it could actually vent.
You have put my mind at ease. Thanks again. This is such a great to get helpful information!
Does anyone know how the front axle fill cap is supposed to release the pressure that builds up during use.
I see the there is a v shape cut in the threads, but I don't see any way for the pressure to release.
When I removed the fill cap after using the tractor, there was obvious pressure built...
Does anyone know if it is still possible to get one of those 3d printed 3 point lever hold down tabs. When blowing snow with my GC 1705, you almost always have to hold that lever down by hand. Thanks for any information.