Recent content by JRA29

I have a Snapper Lt145h38fbv. The lawn more starts moving slower after running about 30min. I thought it was over heating and checked the trans and the fan on top was broken. I replaced the fan and didnt help the problem. Any suggestion will be a great help.

I am needing to remove the boom cylinder from a b5 yanmar, and im having trouble knocking the pin out, its the pin under the floor board i have remove 2 bolts that held a piece of steel that held the pin in place. I cannot get it to budge, i have placed a long bar through the access hole around...

I have a 1968 Case 310G Dozer, its a good runnning machine with a little blow-by. I was wondering about the fan it sucks air in the radiator to the engine by doing so it gets a lot of leaves on the radiator, causing the engine to run warm and operator. Can if this can be reversed, to blow air...

I have a 1970 ford 4000 diesel. It wouldnt crank so i changed fuel filters and notices the wrong filter was attached, after getting the right one still not cranking, fuel is getting to the pump and loosing the small 5/16 bolt on the side of the pump and fuel was squirting out there when running...

I have a 1972 Ford diesel tractor. I had the heads reworked bout a few months ago, due to a blown head gasket, it seems to be exhausting some white smoke, and has strong fumes. Could this be emiting raw fuel? If so how would i correct this.

I have a 1971 ford 4000 i put a new generator and a voltage regulator on just recently. the light in the dash stays on, only to cut off if you disconnect the terminal form the battery or cutting the key off. There is power to both of the terminals at the generator. I took the pos(+) terminal...