Recent content by Jrus

Has anyone made there own third function valve for the loader. Iv got a 45hp NH and have been thinking of putting some valving together to do it. Also is there anyway to make your own rear hyd ports for 3 point implements.

Iv got a 2010 NH T1530 hydro and it won't start. I was brush hogging Sunday and when I was done I disengaged PTO and parked tractor. When I came out later it wouldn't start. The starter would click sometimes but it wasn't turning motor. I took it off bench tested it and it ran fine. I put a new...

Has anyone made there own post hole auger for 3 point? Thinking about using a truck axle to build one. Anyone got pictures or advice?

Iv got a 69 ford 5500 it is currently stuck in 3rd gear or 6th if in high. It shifted great the last time I ran it now I can't get it to move. I'm hesitant to pull the top of the trans up but I'm not sure what to expect. Any one have any advice on this? Also of anyone knows where I can get a...

Buried it up to the frame few weeks ago. Managed to pull itself out eventually.

Iv been looking at tractors for awhile now. Iv narrowed it to either a LS g3038 or a Branson 3520r. The Branson has alot more impressive specs. Heavier tractor more lift capability and more user friendly options. However the LS is cheaper but has a longer warranty loader seems to work more...

Iv got a ford 5500 I recently acquired from an old lady. It was her dads and it was parked when he got to old to run it with only 500 hours on it. Long story short It worked great. Untill now. This winter my suction line collapsed at the tank where the rubber elbow comes out of the tank. It was...