Thank you for the info, much appreciated. No expert on grease but it looked good, I may just take a chance and leave it..... or not. I'll think on that a bit.
I considered that I didn't have a good method for that, I'm going to need something to put the lube back in so maybe I should have purchased something. I ended up just pulling both the vent and fill plug and standing it up on it's edge to get what fluid I could out. Not sure I got it all but...
Chewwy,
Thank you, I had found that info from another post on the forum and had contacted them today. Didn't have any luck by phone but the message gave me a number to text pictures to, have done that and hopeful for some response.
Thank you both for you reply. Any thoughts at all on the coupler movement? I just don't want them to be loose if they are not supposed to be and end up stripping the gears.
Justin
First post here I think. Thank you for your time in advance.
Picked up a Howse 10Ft. Rotary Cutter a couple weeks back. Looked good, sounded good, was close to home but after the purchase found out they went out business a while back. Local tractor repair guy said parts are really hard to...
First time posting here but have been a member for a little over a year. I am new to all of this haying stuff so I have just been reading for knowledge. Purchased a 848 a few weeks back for personal use (Not for profit) and ran it for the fast time last week on a small spot of land with no...