Recent content by justme23005

Wolverine stuff is absolute garbage

My Satoh Beaver with a SSQA I built for it, and my grapple bucket on it.

Seems like this is all I see, every time I look up..... I think I need a vacation...

The logs were lower than the car. I'm not sure where the car was parked in relationship to the pile of logs, but I'm assuming that it was parked beside it. I didn't notice any strange marks other than on a couple of the logs. The scratches are on the hood of the car.

The marks are about 1/4 inch apart, and appear to have been cut into the wood, since it didn't rip the bark. Any ideas? Thanks.

Hi, Has anybody here messed with a chipper with this type of blade setup? I was expecting to see recessed allen bolts... But this is what I saw when I opened her up. I just bought the chipper. Its a 12 inch woodchuck. I adjusted the clearance between the blades and the bed knife, but it...

I bought a brush hog for my Beaver last night.. :D

Hi, I picked up this sickle bar mower a while back.. It didn't run. The carburetor was all gummed up & rusty. I found a good deal on a new Chinese copy of a Honda 6.5 hp engine. I put the engine on yesterday, and ran it for about 5 minutes. it runs good, and works like it should. Can somebody...

OK, I know it's not a utility ATV, but I thought I'd show everybody the ATV that I built. It started out life as a 2003 Bombardier DS650 Baja. When I built it, I had 5 DS650's and this one didn't get ridden very often, so I decided to turn it into a project. I found a Yamaha FZ1 engine...

Hi, I'm looking for a 4 foot brush hog for my Satoh Beaver.

My Satoh Beaver S370D and 1530B case skidsteer.