JWR's latest activity

I also do not depend on fuel to be treated at the pump in the winter, and always treat my own. It's not really cold enough in my area to...

I've said before -- I'm not a fan of additives in general. You are safe doing exactly what your manufacturer says, no more , no less...

...and if you are that close to lacking adequate cooling there is something serious wrong !

It sure sounds like the seat safety switch to me as well. If you want to test the seat switch, pull the plug apart under the seat, and...

I would still bet on the seat safety switch. My previous ZD mower would do that when rolling on bumpy terrain, and it was activating the...

I've had an experience with a waterpump that I replaced and the impeller was plastic and the pump casing was metal. Under load the...

My BX2660 will get hot if I don't keep the radiator clean. Even with the screen in place dirt still clogs the radiator so I need to wash...

I'm still beating on it. Pump looked great inside, went back on. Radiator at shop, guy said his chemicals pretty good. I'm real...

JimBinMi -- you are doing a great job of illustrating the things I hope I never have to do...

Wow, that looks like a lot of work!

Agree with Dodge Man. They do run on the hot side. I've owned 4 Kubotas and maintained 2 more. Every one of the BX ran almost to the...

I owned a BX2350 for about 10 years. They tend to run hot. Mine would get up near the red if cutting really tall grass. Before I even...

Well, yeah, but I could also think that there was just as much oil on top of the engine but it dried up due to higher heat in that area...

gengine is probably onto something for the source of your leak. Experience is worth a lot! I would remove as much obstructive sheet...

I agree. Normally no reason to bleed hydraulic systems. Cycling them (whatever they do, cylinders, lifts, etc.) gets rid of the air...