“I tend to use nylon pull ties (zip ties) to hold things in position; I make to many mistakes for glue.”
I usually do the same. However there is a drip tray that the motor and pump sit on/in. Didn’t want to drill through this to secure wiring harness. Using the correct sized fuel hose with a...
Checked fuel pump rack engagement with forked lever was correct. Loosened throttle plate to properly check govenor springs position and levers. Seems Ok. Bleed system. Unfortunately still same problem.
Edit to add. Checked service manual one spring not in the position suggested. Although I...
Thanks for your prompt responce. I have been editing my initial post to correct any errors and add some additional information I had missed.
Down in the South west of Western Australia
Pump is a “Pumps of Australia” unit. Not exactly sure the name plate identification is difficult to read...
New Member here from Western Australia. Great thread and I have spent several hours reading through this thread. Picked up a great deal of information and wish to thank active members for the effort to educate others.
My interest is with a problem I am experiencing with a Yanmar L48 driving a...