Recent content by Kc8ehd

My tractor came from factory assembly plant in NC with ASTM D5216 which is a propylene-based antifreeze that requires the use of a special ball tester to check its freezing point. A standard antifreeze hydrometer will not give correct reading with this type of antifreeze. After speaking with...

Coolant/Antifreeze is an Organic Acid Technology (OAT), globally formulated, ethylene glycol based coolant, which uses organic acid inhibitors (non 2-EH) to provide guaranteed protection for all cooling system metals. Close enough for government work

Proper way to check antifreeze condition

What type of antifreeze are members here useing ? My tractor is due for an replacement think of switching to an ELC rather than changing every two years ....

Anyone here by chance know what size the lower radiator hose is on an LS XR4040 C is , considering an inline hose heater , the hose is straight and not very long on this model , not for sure if a kats heater would fit .....thanks in advance

New Holland giving error code 3305 , Stop on dash lighting and going into limp mode ... has happen twice , both times going down hill with engine holding tractor back , turn key off and restart it will run fine all day .. any ideal what could cause this ?....thanks in advance for your help

Can anyone think of any cons to having adjustable lift arms on both sides (left and right)

Tip : Drain water from fuel filter at the very least yearly Do not depend on the idiot light on dash.

Easy install , nice thing about L.S. - O.E.M. wiper kit is every thing fits ...it is plug and play really cuts down on the cuss words.

A five minute tops install , this kit is a LED no rotating Beacon

Part number 20140820 (M05-1-01) Motor Assy-wiper (Combo SW)

Has anyone here installed a rear wiper kit ,?

Need part number for rear wriper kit XR4040C or a New Holland cross rear wriper

Tip: Torque you wheel nuts/bolts at least yearly , damage to wheel lug holes from loose lugs isn't covered under warranty , and it's not a cheap fix . My XR4040C shop manual specs wheel nut/ bolts 16mm [5/8] torque to 131 - 145 foot pound . A torque wrench with 12 inch extension and 24mm...

Will be dropping off at repair shop , hopefully they can locate the problem...Will keep as spare if repairable...