Recent content by kchansen

I did not. I will look that up. Thank you!

I replaced my 2155 tractor fluid & Filter after removing / repairing the my Rocker Shaft problem (Arms would not lower - Broken load spring and bent load link missing "C" clips). The fluid looked really good, but I was suspicious of the NAPA fluid. I bought the tractor used and replaced the...

Anyone install a block heater on kx57-4? I want to install and curious where it goes. Secondly this is my first excavator, which I bought used. Curious what the practical temperature is for operation? I'm thinking 20. I live in Palmer AK. Tks, Ken BTW I am flushing the hydraulics with napa AWS...

Looks like the spring inside is broken or came off. There is no resistance to the load arm. I'm using as is, which is good enough for snow removal with the box blade. Once I have completed other maint projects I will service the Rockershaft assy and update. Thank you!

Does anyone has the diag manual TM4436? Was curious if it offers solutions. Curious if a library has it.

Hello. This morning I went through the adjustment procedure laid out in TM4435 (page 70-15-15+). I adjusted 17, the load control arm and then 7, the commencement of lift. At one point my arms went all the way down. I thought it was fixed with this adjustment, but nope. I tried multiple things...

Thank you Spike56. Will reread tonight and see if I'm missing anything and report back.

Thank you Tx Jim. That is helpful. My drop rate screw appears to function properly, I've tried multiple tests with this, but maybe something is going on with this. I was pulling the transmission out of my 95 Dodge Cummins last night so it got to late to check the tractor. Will try today or...

Thank you. I will check out today. There are not many local resources on tractor maintenance, so this is greatly appreciated.

Thank you, I will check this out tonight and reply. I greatly appreciate your time and advice.

Hi. Since buying this, I have had intermittent periods where the rock shaft arms will not lower all the way. I would play with the load arm; however after running the rotor tiller too deep the arm is now only going full height to perhaps half. I bought the manual, but reluctant to open up. It's...

Hello. Was Brush hogging in the woods and working it hard, Lifted the Arms and then it would not go down. I had Draft control up. The tractor was slowly becoming harder to have life arms go down. Would not go down all the way with draft arm up, when I moved down and pushed down then I could get...

Hello. When my temperature sender begins to warm the resulting resistance change causes my warning lights to illuminate (low oil, hyd warn, and others). I have a black wire that is not connected near the starter in the wiring harness. I believe this needs to go to the 12V side on the starter...

Here is the yoke with the JD page that describes the part. When I try this on the flange, I get Obsolete and no specs. Curious if anyone has access to JD pubs that show the flange spec, pnL37213 PART DETAILS Part Number: AL34711 Part Price: 153.31 USD On Hand: 0 Check Other...

Hello. I have a FWD 2155 which I recently purchased with a missing front drive shaft and bent RH/LH lift links. These parts are obsolete per JD. I'm looking calling salvage yards no luck yet. So It may be time to fabricate. Was curious if someone knew the dimensions or source to purchase the...