fused red wire to solenoid blowing 25 amp fuse when ignition turned .when fuse is replaced glow plugs can be used and as soon as ignition turned to right , pops the fuse .
Red fused wire to solenoid is popping fuse , is this a starter problem or is there something else causing the problem, i cannot start due to the problem . The fuse is fine to use for glow plugs but is blown as soon as the key is turned . thanks in advance
The starter is not engaging completly all the time , it is grinding the flywheel .It has been cold -15 celcius or so but is indoors . It sounds like the the gear is not being thrown out far enough. I believe it is the bendix? My brother mentioned to lube the shaft but i always thought that just...
03 hydro suction screen magnets are not present in the pre filter of trans . My service manual shows them and states "magnets " meaning 2 i suspect . My dealer shows nothing in his parts book and wondering if these magnets are ptresent in all 4400 - 4600 on and on . I would appreciate some...
when in forward i notice a surge when travelling , this condition exists when pedal is matted , the travel seems fine in and around at part pedal application . Is this an adjustment or operating build of the hydro trans. i am only used to a pwr reverser trans . Could this also be a pump problem .
i thought i would ask if the bleeding down of the stabilizer is the fault of a stabilizer seal on the cylinder or a spool on the b/h levers. It is not weeping any hyd, fluid at the stabilizer cylinder and i cannot see into the spool area . Just thought i would ask if the problem can be easilly...
the tractor has 783 hours and was bought used , the dealer needed to put 2 new pumps on it before i picked it up - problem was weak hydrolics. Are these pumps a problem ? . the other question was the right stabilizer leaks down. It does not seem to leak .
i was hoping to entice a discussion on the shimming of these hydraulic pumps , and is this a common shop item that should be dealt with - if so i would appreciate an education in the process . I notice in a prior post the third manifold in the pump is the work zone to be shimmed . I currently...
i noticed on the install of the loader 2 items i would appreciate some discussion . #1 - the cylinders for the unit are a black colored steel - in the past i notice4d all cylinders to be chrome . #2 the pins on the unit are plastic - almost all of them except for a couple - these others seem to...
The tractor has a shift assembly on the right fender , that is cable operated , the cable routes into it looks to be the hydrollic manifold for the front bucket. It is a little stiff also. What is the function of this lever and cable? Also can i just use a good quality hydrollic fluid in the...
could any7one provide me with a downloadable owners manual for the 2001 - 4600 series JD . I bought from a company and unable to provide me with the book. I bought a tech manual cd and a parts manual , but did not purchase the owners manual becuase of the first 30- minutes used and on the shelf...
just purchased a 4600 with 2000 hrs , any problems i should be aware of - sold solid little kubota L2250 for this and it is definately more product . The loader is a 400 cx and has a quick tach on the 3 point . So lets discuss the japanese motor in this machine - weak points? i noticed the draw...