Recent content by kenb1023

Well I took it apart. No rodent infestation, thank God. I checked all the wires and they looked good. So I decided to just unplug the harness and plug it back in. It made a noise almost like a reboot and poof, everything came back. Now if I can just get my engine problem and rear axel seal...

Went to start my TYM 293 tractor and the Tach, Fuel, and Engine Temp were not working and engine hour meter reset to Zero and stays on even after shutting the engine off. Any ideas of what to look for?

Ok, so here is what I have done. New lift pump added and after 26 minutes it started to bog down again. I disengaged the brush hog and still did the same thing just not as severe. At idle it did seem to be running a bit rough. Almost like a gas engine when you have a spark plug issue and...

Electric Fork lifts are no good in the rain and are constantly needed to be plugged in. If it was raining or snowing we never took them out side. They were for indoor use only. Electric Golf Carts don't have the fraction of load on them as a tractor would.

No reliability track record, short run time, long charge time, temperature limitations and overall costs. This is a pass for me. I will stick with my diesel. Will need to get 50K hours of real field work evaluations, quick change batteries so you can swap and keep working and more real...

He said it was a mix of Diesel and gas. He was at the station trying to figure out why it was smoking so bad when this one old timer came up and asked him about it. He told the story to the guy and he jus laughed. When the owner of the tractor pulled in all hot about someone stealing his fuel...

I have heard of those. My farther in law when he was a kid back in the 50s stole fuel from a tractor for his car not knowing. Car smoked like a mother until he burnt most of it out and added pure gas. Never did that again.

I found the number OQ2715AO-JB on the seal. It does not seem to cross over to anything but it seems it is a JB Industries seal. Frustrating. If I can find the NON-TYM over priced seal I will be ecstatic.

What did you end up doing? My TYM has the same seal it is weeping now. If you have any instructions on how to replace it that would be great to. Never did a tractor HST seal before.

I looked at the Autobest pump. Specs are good but it says for carburetor only. Does anyone even make a diesel with a carb? I didn't think that was possible. Everything I know about a diesel says it is impossible so I figure it was some gas engine description carry over that a very...

I get most of my Amazon orders in two days if it is a Prime supplier. This one is not and is coming USPS

Radiator is clean and filter is clean. I also pulled the air filter out to make sure micky did not set up a home in there. All clean

Ok, did that. RPM slowly came back but dropped when I tried to increase speed. Also, RPM comes back with the cutter engaged and not moving. I will have a new lift pump Friday so we will see what that does.

Well, if the cheep Chinese knockoff works I will look at getting a better one later. Thanks I took a closer look at the picture from Bill's Tractor and Equipment. It is the same friggen pump with another label superimposed over it. If you look close you can see the Chinese knockoff pump...

Ok, here is something that is really crazy. I looked up the part number for the pump and found ELECTRIC FUEL PUMP FOR 5010|6010|6110 MAHINDRA TRACTOR (16999052300) for $235.00. I went and found Amazon.com: ‎zt truck parts 12V 3-5PSI Electric Fuel Pump 68371-51210 for Kubota D1005 D1105 D905...