This old 373d had the voltage reg. 6 wire plug and tractor side 6 wire plug cut off ( plugs missing ). Replaced the damaged alternator with 1980's Mitsubishi alternator ( same 4 wire plug + battery post ). Wired up the 6 wires from the tractor side to the old factory voltage reg. to the best I...
Re: Satoh K3A stalls after 15 seconds, with glow plug always "ON" runs for 90 seconds
It's fixed and running better than before it started stalling. When I first could the engine started after it sat in a field for 8 - 10 years it ran but did not sounded a little odd even before the stalling...
Satoh K3A stalls after 15 seconds, with glow plug always "ON" runs for 90 seconds?
Pulled a Satoh Beaver III ( K3A 3 cylinder ) out of field after it was left stilling for 8 to 10 years. Cleaned the fuel tank (removed rust & water, did not have a fuel cap on the tank for years) and replaced...
Looking for MT373d Temp. Switch. Think it is a 16M x 1.5 thread. Current Temp. Switch has center terminal grounded to other shell even when cold, keep the Temp Warning Lamp (ON) all the time. Know of any optional replace part numbers / vendors? Only marking on my old temp. switch are a circle...
Looking for (2) 12x5 4 bolt rims. Also need (2) turf tires 12x5 or 12x6. All items for MT373d compact tractor. Anyone know of hub adapters to change from 4 lug rims to 5 or 6 lug rims as an options?
I am the 2nd owner of this MT372d with less than 400 hours which runs great / no problems. Have two questions would repainting the tractor increase the value much / what is the value? Any idea on the model year?