Recent content by kennyl123

where to buy david brown 885 selectamatic control valve setting tool. rebuilding control vave and need to adjust valves.

Hi all... does the z225 have a suspension seat available or suggestions how to make it better on the back?

Hey folks... I know this is a really dumb question but I am having prime problems. The new filters came with 3 large gaskets where do I put the third one:confused2:

hi all.... Upon removal of rear oil seal cover and driving seal out I discovered there were two seals pressed on top of each other . Is that correct? or did someone before me just installed wrong?

Hi all, Is it possible to do away with the differential lock on David Brown 885 and tractor would work without it. The reason is I can't get final drive shaft back in I have tried to get a tool made as per specs in my repair manual and local machine shops or either too busy or not interested in...

Hey folks, I recently acquired a 1971 david brown 885 and steering had nearly a whole revolution of slack. I removed steering column and found the ball bearings worn out, I am in the process of rebuilding steering now. Upon inspection of gearbox cover I found that someone had cut the bottom of...

Hi all, My tractor started to pour fluid out of the pto . I pulled the shaft out of center housing and I can pull the shaft out of bearing by hand without removing anything. Is this normal or is something missing or worn out? there was slack from front to back before removing but not bearing...

I have a ford 2000 3 cyl diesel 1972 and it caught on fire ( electrical short) It melted all the fuel hoses from the fuel filter. I have searched ford parts list and all the lines says not serviced the only rigid lines are the intake from tank and the three injector lines. I bought 1/4 fuel...

Hi all, I have a woods rm59-1 and the center blade is cutting higher than the two outer blades. Any ideas?

Does the caster arm on a Woods RM59-1 have bearings in it or does the yolk just free plays inside? Thanks Kenny

Hi guys. I need to know how much gear oil to put in a First Choice RT04-60 tiller gear box. I have searched on line but can't come up with the answer. I have the owners manual but it just says change it and nothing about how much and weight. Thanks

I know I'm gonna sound stupid but here goes My 1972 Ford 2000 diesel 3 cyl has not had any lights or gauges hooked up sense I got it so I bought a new wiring harness and oil pressure switch wire has a female spade terminal on it. The wire on tractor was just hanging down with bare wires like...

HI folks, [I] have a 1972 ford 2000 3 cyl. diesel . The starter drive keeps spinning after tractor starts. Turn key off and still spins, kill tractor and still spins. The only way I got it to stop was to pull starter drive wire off of terminal on starter. What is more likely, key switch bad or...

Hey guys, I have a 1972 ford 2000 and I bought a new generator with tach drive. Hooked up and tach meter don't work. I replace the instrument cluster and cable and It still doesn't work. I took the cable off the drive and put old cable back on, nothing happened. Took cable drive off generator...

Hey guys, I have a 1972 ford 2000 and I bought a new generator with tach drive. Hooked up and tach meter don't work. I replace the instrument cluster and cable and It still doesn't work. I took the cable off the drive and put old cable back on, nothing happened. Took cable drive off generator...