i sure hope you can help me
the controller reads the 2 topcon receivers ok
i just am not getting current to the pvg 32 valves
and I really don't want to have to level out the garden by hand again to plant text month
it takes me a couple days to level by hand
i have no problem with mechanics...
i have built a dual laser box scraper but the hydraulic controls don't seem to work
you inspired me to build my own i am retired machinist and like projects like this
receiver masts are 12 feet tall and hinge down to work on but too tall for in the building
i have a motor grader 9164 control...
i am new to this format
sorry about asking questons you have already answered
i now have the 9164 control and the danfoss valve
not sure about the main fall sensor
have 2 different numbers
9170 and 9622 think a newer version ?? mayve both do the same thing ?
having trouble with the wire...
want to make the same laser box scraper
built back hoe bought the wrong valves open center and it became a jack hammer
expensive mistake
belive there are several versions of the pvg 32 valve want to get the right one
and the correct parts for the topcon controls
i would like to know the parts you used for the controls topcon i have johnson laser with slope settings
built a back hoe and didnt realize i bought normally open valves which made it good for a jack hammer
that was an expensive lesson
so want to get the correct controls think the dvg 32 valve...
i want to build lazer box scraper like yours
built back hoe bought the wrong valves center open was good for a jack hammer
can you give the topcon and control valve info so i dont spend a lot wrong
thanks ken