kneedeep's latest activity

I have a IH end wheel drill but it plants on top of trash requiring a pretty clean seed bed. 4 or 5 passes with disk. I'm thinking a 2...

I'm trying to save at least one, maybe 2 trips across a 10 ac Duck Hole in MS Delta. Right now, the ground is dry and will need 2...

I’m wondering if one is worth the effort or just a ZTR fad. Seems most folks don’t use one?

I have my old contractor rotary laser from working days that still is accurate to 1% slope at 300’. Paid about $800 for it new, bet they...

New to me 60” has the stock grass flap and makes windrows to recut. I need to be able to close the chute off around cabin and wife’s...

Had a broke spring on the pressure plate did the opposite as yours. Need free play in clutch, yours may not be adjusted right.

Only rusty ones I see are from never washing the wet dirt road splatter off the inner fenders. See quite a few rust buckets in town...

I was concerned about having to take a BH on and off my compact tractor, so I bought another tractor. Problem solved!

Slow down on turns

Most GG have a button or a bolt that will ‘burp’ the air out. During hot weather, I keep mine in a bucket upside down as the heat will...

A Dealer told me that most people use too much grease, and they need to learn to only put in enough to do the job. I've gone back to...

That drive shaft section from tractor to the knuckle is bent. It will eventually blow apart after damaging all the u joints. Replace...

If the backhoe has a thumb, that will be a big time grubbing setup! 👍

I think that said 300, not 300k. That fits with "sitting on the lot". I'd be wary of that because 2 years is a long time to not move...

There is a 24 F250 diesel 4WD with 50k miles on CL in Foley AL that Carmax offered them $40k. Bought new camper hauler that is in good...