Recent content by KRH

Going to get an operator's manual. Checked it out on line and the only adjustment that can be made is the rate of drop. I have sent the salesman a message as well. Thanks for your input.

Just bought a used 2017 JD 3025E with a front end loader. Before I made the purchase I noted that the 3 point hitch arms went up and down. I asked the dealer if there were any problems with the machine and he replied in the negative. Now that I have the machine and home and going over it...

OK. Thanks!!!

I am an hour south of Buffalo. Still looking at winches. Looking for a Igland dealer. Found one in Vermont about 9 hours away. Would like to find one closer so I can get a look at their line. Thanks

Thanks all for your input. Much appreciated!!!

Thanks!!! The remote would be very handy!!!

Looking at a Tajfun EGV 45A logging winch. Looking for input from other Tajfun owners. Thanks in advance for your input!!!!

Thanks for your response. Looking at a used one that is in good shape with low hours.

Looking at buying a JD X738 4WD lawn tractor. Pros? Cons?

Looking at a Moritz dump trailer. Well built and solid. It has the torsional axle/suspension rather than the conventional axle/leaf spring system. Any experience /comments, good or bad, on the torsional system would be appreciated. Thanks, Kevin

Looking at a used 2006 JD 4720. It has fluid in tires. This 3rd owner does not know what the fluid is. He claims it is NOT calcium. No labels on the rims. If rim guard, I assume it would be labelled as it is on my JD 4520. Safe to assume it would be windshield washer fluid? The...

Looking at a used 2007 4520 with a cab. Lever to raise and lower the rockshaft arms will move only slightly. The shaft that goes into the rockshaft housing will not move/turn. The cable appears to be free and has no kinks or sharp bends. It will move. From sitting all winter could some...

Anybody know where I can buy the quick attach plates/ears to convert a pin on backhoe bucket to quick attach for my JD 110 tlb??? Thanks in advance for your assistance.

Has anyone removed the ROPS/Canopy on their machine? Does it come off easily after you unbolt it and discconect the wires? Did you lift off by hand or with a sling? Thanks.

Hi All: My brother has a 4600 and the fuel cutoff solenoid doesn't work after a number of starts. If you let it sit awhile, it will start. I have taken the solenoid out and laid in on the frame. It will pull the plunger in a few times, but then will stop. If you push the plunger in...