I am going to be installing my heavy duty front strut assembly this weekend on my rtv 900 and was wondering how bad of a job it is going to be and if i need any special tools or any warning any advice would be gratley accepted
i just bought a pair of heavy duty front shocks assembly for my rtv i have the2007 work site model with the hard curtis cab. and i am haveing problems with bottoming out a lot more than my 2004 rec model with out a cab. i have ask my dealer twice and he said thay always put the heavy duty one on...
i was wondering if a k&n type air filter would harm the engine in anyway i have been on there wed site and you can give them the spec and thay have several one that match them pretty good i would leave the inter filter the same just replace the outer one with a reusable one the throw away one...
i have purchased the beready full cab off ebay wth wiper and let me say it a+ it the toughess vinyl material i have ever seen and the ez2cy clear vinyl is the best i have put it threw some rough use with only minor scratch and the wndow is great it come with a wiper and the first thing i though...
had my buggy in the dealer for a new drive line replacment and had him check out a new noise i just started hearing and after two day of trying to reproduce the noise it finally made it he took the back passenger side wheel off and pulled the shaft out and the u joint fell apart in his hand new...
i am having a very bad rattle frome the front end when i run over small rocks unlevel terrain but when on smooth trail it sounds great i have done the anti rattle fix with the set screws and rubber hose which is a great fix by the way the drive shaft is totally quit now the front end noise is...