The pivot point is very free and has been greased regularly. I keep looking to see if there is a return spring or some mechanism that should center it? It's hard to see what its even trying to move.
Do you have a electric water heater. I replaced my electric water heater that was leaking with a Richmond unit from Menards. For about 6 or 8 months had lots and lots of air in the system. But only in the hot water. I even called Richmond. I was sure that the heating element was causing it to...
Dealer required a 25% restocking fee. live and learn. They did have the correct parts in stock too!!
Installed all new seals an o-rings and all went very well.
Need to reinstall on tractor and hope there are no leaks.
Then time to look at the backhoe cylinders. One stabilizer is leaking...
None that offer that kind of service, mostly industrial stuff.
I would like to use OE stuff when I can. Have more money that brains anyway!! At least on this project!! Ha Ha. Thanks for your help.
Might need to learn a few new four letter words two before this is done I already used all my...
Yes The pic you show is what look like i need.
Of course I was a dumb as! and told the dealer to order this part!! I looked online and found a
parts manual for what I thought was for
my loader. Oh well just another leaning experience. Thanks will be heading to the dealer again tomorrow.
I was...
I have a b21, about a 2008 model I believe, been a super good unit. I have started to notice some hyd cyl.
are starting to leak slightly on both the backhoe and the loader. So I looked up the seal kit for my loader which I believe is a model TL 421 I have a parts manual and the cylinder that I...
I Have a b21 kubota and would like to get a three point chipper, But once I start looking it seem like a decent one
requires more that 13.5 pto hp --- Any good idea's or should I look for a stand alone chipper?
--I have about 40 acres that have a been left alone for the last 30 years, lots of...