Recent content by kuby

Is rolling it into a fire. Buggerd up my shoulder and leg and yes my pride.....

where could I find the front diff gears for a L245 DT??

owning-ML-745105-ML- Posted in wrong forum.

Does anyone have a good plan for a simple potato hiller?

My old L245 is giveing me headachs with its charging system and have mounted a GM delco altenator on it but am wondering how to wire it. The main red is easy but am confused to know which other wires need to be hooked up? Thanks Bob

My l245dt needs a new cap and was wondering what the pressure should be? The old cap is from Japan and says 0.9 but not sure if it is bars or kpa's or pounds. The dealer wants $24.00 for one......

Anyone here make a tree scoop? I need to move around about 200 trees and ain't crazy about useing the banjo (shovel) again. It looks like I could just carve up a 2 foot x 36" 3/8 pipe. Thanks Bob

I ran my Kubota l245dt out of fuel and when I got it running again after bleeding, it is running rough at part or half throttle. At full throttle it runs goood but part is rough. I replaced the fuel filter and drained the fuel tank and there was water and rust present so after refuleing...

Does anyone know if their is a coupler for the front crank available? I want to hook up another hydraulic pump to the front of my engine. This is on a L245DT

What is the max hours you would accept on a used Bobcat? 500, 1000, 2000???

I built a new bucket for my tractor from a drawing on here but am a little confused on how to and where to put the new brackets. My old bucket has a strait back on it and the new bucket has quite an angle and this is what makes it a little confusing to me.

My kubota L245DT is over charging 16-18 volts. I replaced the regulator but it still overcharges. Any idea's?? Thanks Bob

Thinking of instaling it myself but how does one fuse the lines together?? The lines are simuler to naturel gas lines.

Was pushing up dirt with my L245DT tonight while pushing under load my front wheels started bouncing and banging. I put it in the shop and pulled off the driveshaft and the splines on the end that enters the front axle are worn down to a beveld end.. Do you think that the pinion spline would be...

I know nothing about these things I usualy get a cat or hoe to remove stumps. So how deep will they go? Would one be able to cut around a big old popler tree and then push it over??? I have been digging the sides of a tree with my 25 hp kubota and then pushing it over but that takes a long time...