KWentling's latest activity

There should be some numbers on that broken bearing. I would look for those, then compare with the parts diagram that Bob Rooks have...

The Husco is a series 5000 but the configuration numbers are proprietary so no help there. I can't make out the letters and numbers...

Looks like a 110 TLB should flow 23.6 gpm.

A picture of the nameplates would be helpful.

yes, it was this one for me. it was full of crud. I cleaned it, flushed everything and all is well now.

Almost a sure thing to bend a rod using ether on a Kubota engine.

NOOOOO! No ether on any Kubota!

If the stop solenoid is removed and the starter spins over good, there is nothing electrical keeping it from running except the lift...

Did you use the glow plugs at all? True that in warm weather you don't need them much but you do need to let the glow plugs run a few...

The blowing up filters (at the sealing surface) is a real thing. I've read of this multiple times here and on OTT. If I recall correctly...

Not the spring. In this case it would be ball.

A note of caution: Running hydrostatic trans without charge flow for any period of time will potentially damage the hydrostatic pump. It...

Good point. I would expect within a few seconds one would know one way or the other.

If it were mine, I would clean the relief and make sure the "spool" slides freely in the bore. Might even be tempted to bump the starter...

Best I could do is take pictures and attach.