KWentling's latest activity

I replaced the seals and bearings yesterday, as well as doing full service (except the lash adjustment (not needed yet due to hours))...

You are picking on the wrong relief valve. I would really like to see a schematic of a BX24. There are changes between my BX22 and the...

How did you determine that excessive flow is going to the filter? If and I repeat if you are talking about the filter that screws onto...

Looks like it's $200 from Kubota, or you could fabricate one with some coarse screen.

Pretty late to the party here, but looking at the WSM for my BX22, the filter is in the HST Loop. I would expect the problem to be stuck...

It helps too if you use the curl function as you load the bucket. It has more power than you lift function.

My opinion (retired machinist/millwright). The one bolt failure is definitely cyclic. I think the problem is loose hub to shaft fit and...

After reading several pages of issues THIS needs further investigation! The fit of the flange to the shaft should be "near perfect". In...