Recent content by KyleB83

Would this be it, victim to some aftermarket wiring?

Jim, would this have a single wire coming off the end of it? I am digging through everything 410c related here to see if it gets me closer on mine. Pre-starter problems, and even still, when cranking, the bucket starts pushing down, almost as if you are holding the lever while starting it. I...

took the starter back off and to the place that rebuilt it.. tested great so they pulled it totally apart and everything inside still looks brand new. I am thinking that either my ignition switch may have an intermittent failure since sometimes the tractor will fire up beautifully and run.. or...

I only get 12v through the small wire that goes to the solenoid when the key is in the start position. I lose 12v when you release it to the run position

On our JD 410C backhoe, we had to have a starter rebuilt.. I installed it, fired up the machine, and about 3 minutes later there was smoke pouring out of the battery box and the starter. Took that fresh rebuild back and they rebuilt the solenoid, and I replaced both batteries and the cable, but...

I’ll walk out to our 410c tomorrow and see what I can find if it will help. I remember being told there was 2 dipsticks for 1 reservoir tho

It’s alive!!! we finally had a few days to focus on it and after rebuilding the pump that the primer was on, replacing a collapsed fuel line, and fully charged batteries it fired up and ran! father in law then had the bright idea to fill the fuel tank and add some cleaner stuff to it. Now I’m...

My father in law has a CK35 that was under water.. COMPLETELY under water.. I need something to do on my off days that makes me want to cuss and pull out more of my hair, so I decided to take a crack at seeing about reviving this thing. Hopes aren't very high since its been more than a few...

We have a D53-16 that cranks but wont start. I am getting diesel all the way up the fuel lines to the injectors. Even trying the gas soaked rag only gets it to run for a few seconds. I am leaning towards clogged injectors.. any tips or tricks to unclog them?

My father in law can't find the service manual we have for the 410C, and the local JD says they can't get us another one.. Anyone have a link or pdf to one? Sucks that $300 binder of papers just disappeared

Hey everyone! Been lurking for years and finally got myself setup here We have more than a few pieces of equipment that Im learning and I cant wait to help others where I can We have.. John Deere 410C Backhoe Gehl 303 Mini Excavator Bobcat T650 Kioti CK 35 (that I think is past repair)...

Hey everyone, I just got my father in laws 410C back alive after 2 years and it won稚 pull in any gear in either direction. Im scared its the clutches or the pump.. All the other hydraulics work smoothly.. Any suggestions?