Recent content by KYMike

  1. K

    HP for a 3510 @ 1200 RPM?

    I need help figuring out what my PTO generator can power in my house (DHW, range, heat pump, etc.). I have a 3510 (30 PTO hp @ 2600 RPM) and a Winco 25kw generator. I figure a capacity of about 15kw at full RPM in the 540 PTO setting, but how do I figure what the hp is when using the 1000 PTO...
  2. K

    Safety of half-folded ROPS

    I've noticed that with the ROPS on my 3510 folded halfway down (pins inserted behind the locking bracket), it is just low enough to fit into both my garage & barn. I know that the official line must be that this is not protection, but I'm tempted to leave it in this position during this time of...
  3. K

    FEL cylinders bleeding off

    On my Branson 3510 (65 hrs), both the boom and bucket bleed down when parked. Put a couple hundred pounds of gravel in it and measured it over 2 hours. The bucket cylinder gained 1/2 inch and the boom cylinder lost an inch. Never heard it pop or anything, but every 15 minutes I measured both...
  4. K

    Toolbox for Branson 3510

    Just sold my '61 Ford 601 (2WD, no FEL) for a new Branson 3510 4WD /w FEL. Although it's way more than I need for my 4 acres, I love it! BUT - where the heck can I install a tool box? No room I can see on the floor, under the carriage, or on the axles or frame. I was thinking about a small box...
Top